• Clothing
• Skate
• Skateboarding
• Skates
• Wheels

Skateboard

A skateboard is a narrow platform with attached wheels, developed in the twentieth century from a scooter, for recreation and transportation, typically by young people.

It is typically made of wood, 76-91 cm long (2 1/2 to 3 feet) that is attached to 2 metal parts called trucks, which hold the wheels in place. These trucks are made of two parts: the top part of the truck is attached to the bottom part of the skateboard and is called the baseplate. The bottom part of the truck is called the hanger. Between the baseplate and the hanger are bushings (other names are rubbers and grommets) that provide the spring mechanism for turning the skateboard. A bolt called a kingpin holds the truck parts together. Attached to the two ends of each truck are wheels. On trains, and other vehicles, the similar item that holds the wheels to the vehicle are also called the trucks. Also inside of the wheels you need bearings. Skateboard bearings are washer like pieces that fit inside the wheel. They are necessary for a smooth ride.

Skateboards are used for skateboarding and skateboarding tricks. A person who rides a skateboard is a skateboarder.

History of the skateboard

In the beginning, a skateboard was just made of wooden planks, little more than two by fours with the wheels from roller skates attached to the bottom.

Stage two was the plastic surfboard imitations that were small and unstable. The wheels began as clay but were later replaced with plastics.

Stage three was the attempt to make them more interesting and flexible. They all had kicktails now, an approximately 20 degree slope up of the last 7.5 or 10 cm (3 or 4 inches approx.) of the board, behind the back wheels. Materials included fiberglass ply (successful but seldom seen now) and aluminium (bad idea because the edges became very sharp). (The aluminium board, though, presaged the current skateboard style of having a kicktail at both ends).

Stage four was when the wide boards and trucks came on the scene and everything changed. The tricks that could be performed expanded tremendously and the equipment and control needed to handle extreme vertical terrain was finally available. This was the first renaissance in skateboarding (later followed by the Ollie). Boards were now 20 to 25 cm wide (8 to 10 inches approx.), with wheels well out to the edges. Wheels were generally soft polyurethane and came in a large variety of colors, sizes and degrees of hardness (durometer). The decks had a kicktail still, and a very useful convex surface running the length of the board.

Stage five was when the Ollie took over and the wide boards were too heavy and unidirectional to accommodate all of the tricks being invented. The boards narrowed to 7.25 - 8.00 inches. The front (Nose) is a bit longer and steeper than the back (Tail). The wheels also narrowed to catch on things less and were made much harder to allow more sliding.

Variants include:

• Longboard_(skateboard)
• Snakeboard
• Freebord
• Flowboard
• Hoverboard